Fabric conditioner runs directly down into the washing machine's drum
Resolution
Issue:
- Fabric softener runs directly into the drum
- Fabric softener dispenses too soon
Applies to:
- Front loaded washing machine
- Top loaded washing machine
- Washer-dryer
Resolution:
1. Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer.
2. Avoid closing the detergent dispenser too hard.
Gently close the detergent drawer at the start of every wash cycle.
3. Clean the dispenser drawer as described in the user manual.
Download .
Cause:
- Putting too much fabric softener into the compartment
- Pushing the detergent drawer too hard
- Dirt / residue in the dispenser drawer
Tip:
- If the detergent drawer is opened at the start of a cycle, the fabric conditioner flows directly into the drum while the water is filling up.
- It can be checked only after the second time when water fills up. Up to this point, the fabric conditioner should be there.
The maximum level of fabric conditioner is indicated on the lid.
Was this article helpful?
Related Articles
- Connected appliances - The application cannot connect to the appliance
- Washing machine stops in the middle of a cycle
- Washing machine displays error message E40, E41 or emits 4 beeps / 4 flashes
- The door of the washing machine cannot be opened
- The washing cycle is shorter / longer than indicated on the display
- Washing machine displays error message E30, C3 or emits 3 beeps
- Connected appliances - problems with onboarding
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Why is there water or moisture is in my washing machine before the first use?
- Washing machine's door opens during cycle