Washing machine inlet hose is leaking
Resolution
Issue:
- Washing machine inlet hose is leaking
Applies to:
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution:
1. Check the following:
- Inspect the inlet pipe adapter on the wall or water tap
- Check if the pipe connection is screwed on and tightened properly
- Check if there is no leak coming from the tap
- Check the water supply connection to the inlet of the machine
- The connection should be screwed on and tightened properly
Note: Fault due to installation is not under warranty and you may be charged for a service visit by an engineer, even during the warranty period.
Warning: Do not use pliers or any other similar tool to tighten the pipe connection. It should be tightened only by hand!
2. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Important: If the hose is damaged (separated or cracked), disconnect the water supply to the machine and contact Authorized Service Centre.
Was this article helpful?
Related Articles
- Cleaning the washing machine’s rubber seal if it's dirty
- Washing machine displays message: "Top up salt" and error code EF8
- The door of the washing machine cannot be opened
- Connected appliances - The application cannot connect to the appliance
- Washing machine stops in the middle of a cycle
- The "drum cleaning" icon shows on the washing machine display
- How to clean the washing machine detergent drawer
- Washing machine displays error message E40, E41 or emits 4 beeps / 4 flashes
- The washing cycle is shorter / longer than indicated on the display
- Washing machine displays error message E30, C3 or emits 3 beeps