Washing machine - How to replace the drum paddle (1)
Applies to:
- Washing machine
Resolution
Always refer to the safety information in your product's user manual before carrying out any repair or maintenance work. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Be sure to wear safety goggles if you're tinkering or fixing anything with springs in it.
WARNING! RISK OF PINCHING
Wear safety gloves if you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not suitable for children under 3 years. Keep all small parts and packaging away from children.
Only adults should use or install the product.
Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that DIY or amateur repair can have safety repercussions if not done right and might void the warranty. Having the necessary know-how is crucial.
HOW TO REPLACE DRUM LIFTER
1. Using a small, but sturdy flat bladed screwdriver press down the securing tabs inside the drum lifter to release the lifter’s tension to the drum.
2. Once both tabs have been compressed you will be able to slide the lifter towards you to release.
3. To put it back together, do the steps backwards. Make sure the paddle is firmly in place by pushing up the two tabs into the plastic casing in the drum lifter to make it tight after you've put the paddle back in its spot. Also check that all six feet on the drum lifter are in their proper slots on the drum.
