Washing Machine - How to replace the inverter board

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you perform maintenance or repair work involving belts.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years due to choking hazard. Installation and use should be performed by adults only.

-

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE INVERTER, ELECTRONIC BOARD

1. Unscrew the six PH2 screws on the back panel and lift from the bottom to release the securing tabs.

2. Carefully disconnect the two top wiring connectors from the heating element. Be careful not to damage the connections.

NOTE: Ensure that all wiring connectors are correctly fitted during reinstallation. Be careful not to damage the wiring connectors. Unscrew the two 8mm screws holding the inverter board to the body of the appliance.

3. Lift the inverter board out from the base of the appliance and lift out of the washing machine.

NOTE: You may need to push against the drum to gain space to maneuver the inverter board out.

4. Note: When reinstalling ensure that the wiring is clipped back into the inverter board to keep it secure.

5. Use a small flat bladed screwdriver to unclip the two front and two back invert board covers and then slide the cover up to remove.

6. Carefully disconnect the wiring connectors from the inverter PCB and unhook the wiring to release.

NOTE: Ensure that all wiring connectors are correctly fitted during reinstallation. Be careful not to damage the wiring connectors. It is recommended to take a photo before disconnecting to ensure all wiring is refitted into the correct position.

7. When reassembling, repeat steps in reverse order.