Washing Machine - How to replace the commutator motor

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you perform maintenance or repair work involving belts.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years due to choking hazard. Installation and use should be performed by adults only.

-

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE COMMUTATOR MOTOR

1. Unscrew the six 7mm screws on the back panel and then pull from the bottom corner to unclip the back panel from the washing machine. (NOTE: Ensure that all clips are firmly pushed back into place during reinstallation).

2. Carefully pull the drive belt up and away from the drum pulley to remove.

Note: Be careful not to catch your hands between the pulley and the belt.

3. Note: To reinstall wrap around desired notch position on motor shaft and follow step 4.

4. Slowly pull the belt around the drum pulley using your hand to keep tension, until the belt is fully connected to the motor shaft and pulley with tension.

5. Unscrew the four 8mm bolts on each corner of the commutator motor.

6. Carefully slide the motor back to release from the four retaining lugs on the drum.

Note: When reinstalling, ensure that all four lugs are correctly repositioned.

7. Carefully disconnect wiring connectors from the motor earth and main motor supply cables. Be careful not to damage the connectors.

8. Lift out the motor to remove it. Note: When removing it you may need to push against the drum/angle up motor to release.

9. When reassembling, repeat steps in reverse order.