Tumble dryer's Condenser LED is on
Issue
- Tumble dryer Condenser LED is on
Resolution
If your tumble dryer's Condenser LED is on, it typically means that the condenser unit needs cleaning. This is a common maintenance alert found on condenser and heat pump tumble dryers.
1. Clean the condenser, filters and air ducts.
Refer to the article: Cleaning tumble dryer filters and condenser.
How to Maintain a Tumble Dryer
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- Tumble dryer displays a padlock
- AEG Tumble dryer stops after a few minutes of the cycle
- How long does a full load take to dry in a dryer – heat pump vs condenser?
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up
- Cleaning tumble dryer filters and condenser
- Tumble dryer’s water tank is empty
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E80