Tumble dryer displays error message E50
Resolution
Issue:
- Tumble dryer displays error message E50. It indicates a motor or software problem.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
2. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- How to change the dryer door opening directions?
- Tumble dryer displays error message E60 and does not heat up
- How long does a full load take to dry in a dryer – heat pump vs condenser?
- Tumble dryer drum does not rotate, no error message
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays a padlock
- AEG Tumble dryer stops after a few minutes of the cycle
- Start - Pause LED flashes on tumble dryer
- Cleaning tumble dryer filters and condenser
- Tumble dryer’s water tank is empty