Tumble dryer does not switch on after a drying cycle
Resolution
Issue:
- Tumble dryer does not switch on after a drying cycle. It indicates a technical problem with the appliance.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Contact an Authorized Service Center.
We recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Tumble dryer displays error message E60 and does not heat up
- Cleaning tumble dryer filters and condenser
- Start - Pause LED flashes on tumble dryer
- Tumble dryer’s water tank is empty
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer does not stop when the cycle is finished
- How long does a full load take to dry in a dryer – heat pump vs condenser?
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E80
- Tumble dryer does not start / does not work