Tumble dryer displays error message E40
Issue
- Tumble dryer displays error message E40
Applies to:
- Tumble dryers
Resolution
1. Check if the door is properly closed.
Make sure that the laundry is not trapped between the appliance door and rubber seal. The cycle won't start with the door open.
2. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer ends the programme immediately after the start
- Tumble dryer does not heat up
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message "Err"
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Tumble dryer drum does not rotate, no error message
- Tumble dryer displays error message EHO, EH0
- Tumble Dryer generates scraping/rubbing noise while drum rotating