Tumble dryer displays error message C6
Resolution
Issue:
- Tumble dryer displays error message C6
Applies to:
- tumble dryer
Resolution:
1. If the tumble dryer displays error code C6, there is a problem with the moisture sensor.
The cycle takes longer than normal, more than 4.5 hours.
- Check if the machine is connected to an grounded socket.
- If not, there is a problem with the moisture measurement, which can be repaired by an Authorized Service Center.
2. To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Tumble dryer does not heat up
- AEG Tumble dryer stops after a few minutes of the cycle
- Cleaning tumble dryer filters and condenser
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer ends the programme immediately after the start
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message "Err"
- Tumble dryer drum does not rotate, no error message
- Tumble dryer displays error message EHO, EH0