SenseBoil indicators blink on induction hob
Resolution
Issue:
- SenseBoil® indicators blink
- SenseBoil® function does not work
- Cannot activate the SenseBoil® function
- How to use the SenseBoil® function?
Applies to:
- induction hobs with SenseBoil® function
Resolution:
1. Make sure surface of hob is dry.
2. Finish previous cooking activities or choose a free cooking zone without any residual heat.
If all cooking zones are already in use or there is some residual heat on all of them, the hob emits a beep sound, the SenseBoil® indicators blink and the function does not start.
3. Select a cooking zone within 5 seconds of activating the SenseBoil® function.
4. If the above advice does not work, check and change power limitation settings on the hob.
Refer to the full description available in the user manual supplied with the appliance.
Download .
Caution: Make sure that the selected power fits the house installation fuse. Technical help is recommended.
Was this article helpful?
Related Articles
- Gas hob - Ignition issues
- When switched the gas hob OFF and ON the message F appears, burners cannot be ignited
- My hob does not turn on
- How to turn off DEMO mode in Electronic gas hob?
- Hot plate switches itself off / beeps
- Hob display flashes between two figures / stuck on simmer / unable to use all zones at the same time
- Hob displays message F
- What cookware is suitable for cooking zones with induction heating?
- The stainless steel frame of the ceramic hob gets very hot
- The SenseBoil function does not work in my Electrolux induction hob