When I open my AEG tumble dryer, there is a large amount of lint / fluff (video)
Resolution
Issue:
- When I open my tumble dryer, there is a large amount of lint / fluff
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Check the air circulation while cleaning.
2. Clean the filters in the door opening.
3. In case of the condenser or heat pump tumble dryer also clean the condenser / heat exchanger, located at the bottom of your appliance.
4. In case of the vented tumble dryer, check if there is unrestricted air flow through the vent hose and through any wall.
5. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Cause:
- It is normal that lint forms during the drying process and it cannot be avoided. This process is very dependent on the load (e.g. new towels, fleece etc.).
How to change the fluff filter of your tumble dryer:
Was this article helpful?
Related Articles
- Tumble dryer's Condenser LED is on
- Tumble dryer emits unpleasant smells
- Tumble dryer displays error message E60 and does not heat up
- Start - Pause LED flashes on tumble dryer
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer emits unusual noises
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer does not work / does not react
- Tumble dryer does not heat up
- Tumble Dryers - Overview