Washing machine's door can be opened and water runs out onto the floor
Resolution
Issue:
- Washing machine's door can be opened and water runs out onto the floor
Applies to:
- Front loaded washing machine
Resolution:
1. Start a draining cycle before turning off the machine and opening the door, otherwise the water will run out onto the floor.
2. Contact an Authorized Service Center.
If the door can be opened with water in the machine and the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Cause:
- If a wash cycle with a "Rinse Hold" was chosen and the machine was turned off by using the cycle selector or disconnecting it from the power, the door can be opened after a few minutes, even though there is water in the machine.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- Connected appliances - The application cannot connect to the appliance
- Cleaning the washing machine’s rubber seal if it's dirty
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- How to reset WiFi network settings on my Electrolux washing machine?
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- The "drum cleaning" icon shows on the washing machine display
- Washing machine stops in the middle of a cycle
- Where can I find appliance's PNC number?
- Washing machine displays error message E90, E91, E92, E93 or E94
- Washing machine’s fluff filter is jammed, cannot be removed