Tumble dryer displays error message "Err"
Resolution
Issue
- Tumble dryer displays error message "Err". It appears when there is an attempt at changing a cycle or settings after the cycle has started or chosen option cannot be used with the selected cycle.
Applies to
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution
1. Switch the dryer off and on, then select the desired cycle and options.
Additional information can be found in the user manual.
Download the .
2. Make sure that the door is fully closed before starting the programme.
Was this article helpful?
Related Articles
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer displays error message E40
- Tumble dryer displays error message E60 and does not heat up
- Tumble dryer does not start / does not work
- Tumble dryer's Condenser LED is on
- Tumble dryer displays error message E50
- Tumble dryer not drying, not drying properly, too long drying
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- Tumble dryer displays error message EHO, EH0
- Tumble dryer does not stop when the cycle is finished