Tumble dryer displays error code E70
Issue
- Dryer shows error message E70 on the display
- E70 code
Applies to:
- Dryers
Resolution
1. Reset the appliance's control electronics by unplugging the appliance for 2 hours and then plugging it back in.
2. If this does not solve the problem and the error persists, contact our Consumer Care Centre
A service visit by one of our approved service providers is recommended.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Cause:
- Error code E70 indicates a problem with the temperature sensor
Was this article helpful?
Related Articles
- Tumble dryer's Condenser LED is on
- Tumble dryer emits unpleasant smells
- Tumble dryer displays error message E60 and does not heat up
- Start - Pause LED flashes on tumble dryer
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer emits unusual noises
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer does not work / does not react
- Tumble dryer does not heat up
- Tumble Dryers - Overview