Iron Aid dryer does not start
Resolution
If the Iron Aid tumble dryer does not start, fill the steam tank up to the MAX level.
- Check the contents of the condensation and steam water tank. This is also indicated by the LEDs on the right side.
- If the icons are still illuminated , contact an Authorized Service Center.
You can contact an Authorized Service Center by clicking on the link below.
Was this article helpful?
Related Articles
- Tumble dryer ends the programme immediately after the start
- Tumble dryer displays a padlock
- Condenser tumble dryer does not dry properly and/or does not heat up and/or shows wrong time duration on the display
- Tumble dryer displays error message EHO, EH0
- Cleaning tumble dryer filters and condenser
- Tumble dryer displays error message E50
- AEG Tumble dryer stops after a few minutes of the cycle
- Start - Pause LED flashes on tumble dryer
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Tumble dryer's drying results are poor and laundry is damp after drying